Baldor MicroFlex e100 ETHERNET Powerlink AC Servo Drive MFE230A003

Baldor's MicroFlex e100 is an advanced AC servo drive which integrates 

the capabilities of real-time ETHERNET Powerlink into controls for 

superior performance, network integration and cost savings. MicroFlex 

e100 is compatible with the NextMove e100 motion controller to provide 

a fully integrated solution using real-time Ethernet. 

MicroFlex e100 is a compact servo drive, available in single phase 

from 110-230VAC or 3 phase 230VAC operation in current ratings of 3, 

6 and 9A. It provides high performance servo control for both rotary 

and linear brushless motors with its powerful DSP (Digital Signal Processor) core. 

Features:

Brushless servo drive with onboard ETHERNET Powerlink for real-time control over an Ethernet network 

Integrated Ethernet hub allows simple daisy chaining of drives 

CAN in Automation (CiA) DS402 complient 

CANopen DS401 network manager for low cost I/O expansion 

Control of both rotary and linear servo motors 

Direct online single-phase 115-230 VAC or 3 phase 230VAC 

3, 6 or 9 Amp continuous with 2x overload for 3 seconds. 

Panel-mounting enclosure 

Universal encoder interface supporting: incremental encoder; synchronous serial interface (SSI); EnDat v2.1/v2.2 and 1V Sin/Cos encoders 

4 digital inputs. Opto-isolated 24V. Two inputs can be programmed to capture axis position within 1 micro-second 

2 digital outputs. Opto-isolated 24V PNP. 50mA per channel 

Auto-tuning wizard and software oscilloscope facilities via Windows front end 

Notch filters to eliminate mechanical resonance 

LED status indicators for error and communications notification 

USB port for configuration 

ActiveX libraries supplied free of charge  

Type

MFE230A003B

Power Requirements

 1 or 3 Phase 105-230 VAC 50/60 hz

Current rating 

3 Amp continuous 

6 Amp peak 3 seconds

Feedback  devices Universal Encoder Interface, supporting:  

  - SSI single and multi-turn absolute encoders  

  - BiSS single and multiturn absolute encoders   

  - EnDat absolute encoders (v2.1 and v2.2)  

  - Incremental encoders (with Hall effect sensors). 5V differential signals.   

  - Hall sensor only for DC trapezoidal control  

  - 1V Peak - Peak Sin/Cos analog encoders with onboard interpolation

Additional devices supported by Feedback Option Cards

  - Resolver with simulated encoder output 

  - Incremental encoders (with Hall effect sensors). 5V differential signals. Simulated encoder output.

Refer to technical manual for full description of supported encoder types and manufacturer part numbers

Regenerative braking

Integrated IGBT output. An external regen resistor can be fitted if required

Protection DC bus over-voltage; DC bus under-voltage; Phase-Loss; 

Peak over-current; Motor short circuit; Over-temperature; I2T over current.

hardware dead-time protection, motor thermal trip input, network failure modes.

dimensions and  weight

H: 180 mm (7.09") W: 79.6 mm (3.13") L: 157 mm (6.18 ").Weight 1.5 Kg (3.3 lbs.)

operating Temperature Range:

Temperature range 0˚C to 45˚C (32˚F to 113˚C) with derating to 55˚C

Shock Vibration

10G Shock    1G, 10-150Hz Vibration

Altitude / humidity

1000m (3300ft) nominal. Derate 1.1% /100m (per 330ft) above 1000m (3300ft). 

/ Humidity - maximum 93% non condensing